[WLANware] basic setup in webinterface

[Manuel Munz]

On 05.11.2012 15:07, Randall wrote:
> dear all,
> 
> using some wr841nd routers to setup a mesh and currently using some
> images generated by http://meshkit.freifunk.net
> 
> by using the "mesh wizard" in the web interface its quite easy to have
> some routers connected to each other in ad-hoc mode.
> 
> however....
> this does not propagate a visible wifi signal  where clients can connect
> to one of the wifi routers.
> 
> not sure if its supposed to be or if you are required to configure a
> second wifi network for the clients to be connected instead of both
> clients and olsr on the same signal.
> 
> the questions asked in the "mesh wizard" "DHCP will automatically assign
> ip addresses to clients" leads me to the assumption that it should not
> be needed to set up another wifi network in "acces point" mode.
> 
> 
> much confused ;)
> 
> Randall

Hi Randall,

indeed, there should be a dhcp server running on the adhoc network, did
you test that? or is there no visible adhoc network on the clients at all?

also note, the images there are still experimental, so expect some bugs
and that the repositories may disappear any time. also, feedback is very
welcome.

Regards, Manuel

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 198 bytes
Desc: OpenPGP digital signature
URL: <http://mailman.freifunk.net/pipermail/wlanware-freifunk.net/attachments/20121105/cb00a2c5/attachment.pgp>