[WLANware] basic setup in webinterface
Randall
randall at songshu.org
Mon Nov 5 15:07:10 CET 2012
dear all,
using some wr841nd routers to setup a mesh and currently using some
images generated by http://meshkit.freifunk.net
by using the "mesh wizard" in the web interface its quite easy to have
some routers connected to each other in ad-hoc mode.
however....
this does not propagate a visible wifi signal where clients can connect
to one of the wifi routers.
not sure if its supposed to be or if you are required to configure a
second wifi network for the clients to be connected instead of both
clients and olsr on the same signal.
the questions asked in the "mesh wizard" "DHCP will automatically assign
ip addresses to clients" leads me to the assumption that it should not
be needed to set up another wifi network in "acces point" mode.
much confused ;)
Randall
More information about the WLANware
mailing list