[WLANware] batman-adv

[Moritz Warning]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I am glad it is working. :)

enjoy,
mwarning

On 07/26/2013 06:43 AM, brent wrote:
> On 07/25/2013 08:49 PM, Moritz Warning wrote:
>> This will probably help as well:
>>
>> http://www.open-mesh.org/projects/batman-adv/wiki/Batman-adv-openwrt-config
>>
>> regards,
>> mwarning
>>
> 
> EUREKA.
> 
> Have you ever been staring at a problem for so long that you start
> "over-thinking" it, and miss some really obvious errors? That's exactly
> what was happening here- I had mis-matched network names.
> 
> For prosperity's sake (i.e. for someone perhaps parsing the list looking
> for a solution), here's the error message you'd get:
> 
> root at phreeN:/etc/config# batctl o
> Error - mesh has not been enabled yet
> Activate your mesh by adding interfaces to batman-adv
> 
> (which is a bit ambiguously worded in this context but, of course,
> correct- interfaces aren't being matched up properly)
> 
> And "batctl if" would be blank:
> 
> root at phreeN:/etc/config# batctl if
> root at phreeN:/etc/config#
> 
> Now. Here's the *working* configuration I have, which adds the wlan0-1
> interface to bat0 on boot as expected (only changed configs included):
> 
> root at phreeN:/etc/config# egrep -v '^#|^\ .*#' batman-adv
> config 'mesh' 'bat0'
>         option 'aggregated_ogms' 1
>         option 'ap_isolation' 1
>         option 'bonding' 0
>         option 'gw_mode' 'server'
>         option 'bridge_loop_avoidance' 1
> 
> root at phreeN:/etc/config# egrep -v '^#|^\ .*#' network
> config interface 'loopback'
>         option ifname 'lo'
>         option proto 'static'
>         option ipaddr '127.0.0.1'
>         option netmask '255.0.0.0'
> 
> config interface 'lan'
>         option ifname 'eth0.1'
>         option type 'bridge'
>         option proto 'static'
>         option ipaddr '172.16.1.1'
>         option netmask '255.255.255.0'
> 
> config interface 'wan'
>         option ifname 'eth0.2'
>         option proto 'dhcp'
> 
> config interface 'mesh'
>         option ifname 'wlan0-1'
>         option mtu '1528'
>         option proto 'batadv'
>         option mesh 'bat0'
> 
> config interface 'vpn'
>         option ifname 'tun0'
>         option proto 'none'
> 
> config switch
>         option name 'rtl8366rb'
>         option reset '1'
>         option enable_vlan '1'
> 
> config switch_vlan
>         option device 'rtl8366rb'
>         option vlan '1'
>         option ports '1 2 3 4 5t'
> 
> config switch_vlan
>         option device 'rtl8366rb'
>         option vlan '2'
>         option ports '0 5t'
> 
> root at phreeN:/etc/config# egrep -v '^#|^\ .*#' wireless
> config wifi-device 'radio0'
>         option type 'mac80211'
>         option hwmode '11ng'
>         option htmode 'HT20'
>         list ht_capab 'SHORT-GI-40'
>         list ht_capab 'DSSS_CCK-40'
>         option channel '3'
>         option disabled '0'
>         option phy 'phy0'
> 
> config wifi-iface
>         option device 'radio0'
>         option encryption 'none'
>         option network 'lan'
>         option mode 'ap'
>         option ssid 'Project.Phree'
>         option ifname 'wlan0'
> 
> config wifi-iface
>         option device 'radio0'
>         option network 'mesh'
>         option mode 'adhoc'
>         option bssid 'DE:AD:BE:EF:D0:0D'
>         option ssid 'mesh0'
>         option mcast_rate '11000'
>         option ifname 'wlan0-1'
> 
> And, on a reboot,
> 
> root at phreeN:/# batctl if
> wlan0-1: active
> 
> root at phreeN:/# batctl o
> [B.A.T.M.A.N. adv 2013.1.0, MainIF/MAC: wlan0-1/XX:XX:XX:XX:XX:XX (bat0)]
>   Originator      last-seen (#/255)           Nexthop [outgoingIF]:
> Potential nexthops ...
> YY:YY:YY:YY:YY:YY    0.940s   (238) YY:YY:YY:YY:YY:YY [   wlan0-1]:
> YY:YY:YY:YY:YY:YY (238)
> 
> and from the test node (desktop w/ USB Alfa antenna):
> 
> dawid ~ # batctl o
> [B.A.T.M.A.N. adv 2013.2.0, MainIF/MAC: wlan0/YY:YY:YY:YY:YY:YY (bat0)]
>   Originator      last-seen (#/255)           Nexthop [outgoingIF]:
> Potential nexthops ...
> XX:XX:XX:XX:XX:XX    0.450s   (137) XX:XX:XX:XX:XX:XX [     wlan0]:
> XX:XX:XX:XX:XX:XX (137)
> 
> (Apologies for the newline-mangling)
> 
> Thanks for taking a look, Moritz et. al.! Sorry for wasting your time. :)
> 

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.12 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/

iQEcBAEBAgAGBQJR8lI2AAoJECHrh56PP4wpykYIANqGSddP0+PDESFQSnrGHbJf
vG8AlK3j0sufChMYpBhgZxH5b0XTpCKK0IvE+pKQv62yMAqMROdZcSn+K+2QwF5s
tvf2xH0KC+oVFdy7yjhk/hWRqHWAGD0JxmcTDhVYQLWh/SZV3jxk9STB+iXXnRIK
khly7I/uIY0bYQ3YtEeCqnPRUQ/WZ4DxXnssB0LZGj3h1i7HMGE9c+CPUmni7/17
E5MgjEBm7nW2MpIRjU1KbuW1xgKMGuTbQNtTLpcHAovhHewcsf6k5ZREA1ixNUF2
43aieHx4X0BMlFyrozVFgwznsKuIessgL8gvV9OwVY/crIEbqByG+w0LvWcfB+s=
=+WBd
-----END PGP SIGNATURE-----