[WLANware] FW: 'Wiki' freifunk
Bjoern Boschman
jesusch at jesusch.de
Sun Apr 2 18:07:33 CEST 2006
kloschi schrieb:
>if you use different ip adresses for wlan and lan the firmware should
>break up the bridge by default.
>
>mine (on wrt v3.1) looks like below. as you can see eth1 and vlan1 are
>not in the bridge.
>
>lan_ifnames=vlan0 vlan2 eth2 eth3
>lan_ifname=br0
>wl0_ifname=eth1
>wifi_ifname=eth1
>wan_ifname=vlan1
>
>bridge name bridge id STP enabled interfaces
>br0 8000.001217b304cb no vlan0
>
>1: lo: mtu 16436 qdisc noqueue
> link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
> inet 127.0.0.1/8 scope host lo
>2: eth0: mtu 1500 qdisc pfifo_fast qlen 1000
> link/ether 00:12:17:b3:04:cb brd ff:ff:ff:ff:ff:ff
>3: eth1: mtu 1500 qdisc prio qlen 1000
> link/ether 00:12:17:b3:04:cd brd ff:ff:ff:ff:ff:ff
> inet 10.63.1.1/8 brd 10.255.255.255 scope global eth1
>4: br0: mtu 1500 qdisc noqueue
> link/ether 00:12:17:b3:04:cb brd ff:ff:ff:ff:ff:ff
> inet 104.63.1.1/28 brd 104.63.1.15 scope global br0
>5: vlan0: mtu 1500 qdisc noqueue
> link/ether 00:12:17:b3:04:cb brd ff:ff:ff:ff:ff:ff
>6: vlan1: mtu 1500 qdisc noqueue
> link/ether 00:12:17:b3:04:cb brd ff:ff:ff:ff:ff:ff
>
These were the values I used before - also not working
More information about the WLANware
mailing list